40x52x7 mm 45x45° suitable for CBT Italia Necer 99 disc, Necer Plus and Necer series skates
18 stainless steel balls
Road specialist
Shimano Y00091370 1/4" stainless steel balls are replacement parts designed for refurbishing the bearings on certain wheel hubs Shimano. With a diameter of 1/4" (6.35 mm) and supplied in packs of 18, they are used to replace worn balls in a tapered roller bearing, restoring smooth and precise operation to the hub.
Made from stainless steel, these Shimano balls offer good corrosion resistance and are particularly suitable for regular cycling use, on-road or off-road, depending on the hub’s compatibility. Shimano specifically lists part number Y00091370 for certain specific hubs.
Shimano tapered roller bearings use loose balls between the bearing surfaces. Over time, the balls may become scored, corroded or worn, which impairs the smooth rotation of the hub.
Replacing the balls may therefore be advisable during a hub overhaul, particularly if the hub has play, stiff spots or is not rotating as smoothly as it should.
It is recommended that the balls be replaced with parts of a diameter and quality suitable for the hub in question. A ball of the incorrect size may prevent the bearing from being correctly adjusted and cause premature wear.
The packet contains 18 1/4" stainless steel balls. This quantity corresponds, in particular, to the requirements specified by Shimano for certain applications.
Please note, however, that the number of balls required depends on the hub model. Shimano states that the quantity required varies depending on the model. It is therefore important to check the exact part number of your hub before fitting.
Part number Y00091370 is specifically recommended for the following hubs:
For these applications, Shimano and specialist retailers specify 18 balls.
This part number should therefore not be selected solely on the basis of the 1/4" diameter. Several Shimano ball bearings have the same diameter but different part numbers depending on their application.
Stainless steel offers good resistance to corrosion. This is a significant advantage for a bicycle exposed to damp, rain, mud splashes or frequent cleaning.
Bears in good condition also help ensure the smooth operation of the bearing system. During a service, it is advisable to inspect the cones and cupsat the same time : if their surfaces are pitted or marked, simply replacing the balls will not necessarily be enough to restore the bearing to perfect working order.
| Bearings | Stainless steel |
|---|---|
| EAN | 4524667145349 |
| Supplier reference | Y00091370 |
Average rating: 5 out of 5
Based on 1 review
Show attestation (opens in a new window)
Material meets my expectations
No review matches this rating.
1 review shown out of 1
The balls measure 1/4 of an inch, or approximately 6.35 mm in diameter.
The pack contains 18 stainless steel balls.
Yes. Item number Y00091370 is made from stainless steel, which gives it good resistance to corrosion.
They are listed in particular for the FH-MT200-B and FH-TY500 rear hubs, as well as for the HB-7710-R and HB-7600-R front hubs.
No. Even if the diameter is 1/4", compatibility depends on the hub’s design. Shimano lists different ball bearing part numbers depending on the model. You should therefore check the hub’s part number before purchasing.
Yes, provided the cones and cups are still in good condition. If the bearing surfaces show pitting, dents or significant marks, a more thorough overhaul or replacement of the affected parts may be necessary.
Replacement may be considered during a service if the balls are marked, corroded or show signs of wear. Symptoms such as a gritty ride, stiff spots or abnormal play may also warrant an inspection.
When servicing a bike, it is recommended that you remove and clean the bearing components, check the balls, cones and cups, then apply a suitable grease before correctly adjusting the hub play.
Our team suggests
You may also like
Other products
To discover